Teac CD-P800NT-B Bedienungsanleitung PDF herunterladen (Seite 19)

Basic operation

In this section, we explain operations that are the same in

every mode.

1 Press the STANDBY/ON button to turn the

unit on.

When input source set to CD

“CD” appears followed by the CD status on the

display.

When input source not set to CD

The display shows the input source followed by

“Now Initializing…” and then the source status.

2 Press the SOURCE button to change the

source.

Each time you press the SOURCE button, the source

changes as shown below.

CD NET USB(F) USB(R)

When using the remote control to change the source,

press the button for the source that you want to use

(CD, NET or USB).

3 Start source playback.

Auto Standby function

When the Auto Standby function is On, the unit will auto-

matically enter standby mode if there is no audio input and

this unit is not operated for 20 minutes. When the Auto

Standby function is enabled, the ASb indicator appears on

the display (page 47).

Press the STANDBY/ON button to exit standby mode.

Connecting headphones

Before using headphones, first minimize the volume. Then,

plug the headphones (with a standard stereo plug) into

the PHONES jack and gradually raise the volume using the

LEVEL knob.

Always minimize the volume before plugging

headphones in and putting them on. While wear-

ing headphones, do not connect them to or

disconnect them from the PHONES jack.

Moreover, do not turn the unit on or put it in

standby while wearing connected headphones.

Doing so could result in a sudden loud noise that

could harm your hearing.

ENGLISH

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 159 160

Keine Kommentare

Teac CD-P800NT-B Bedienungsanleitung Seite 19