Teac FW-1884 Setup Guide Bedienungsanleitung PDF herunterladen (Seite 11)

TASCAM FW-1884 Setup Guide 11

5 – Connections

Always connect and disconnect equipment to and

from the FW-1884 with the power to all units turned

off.

When turning on power, move from source to desti-

nation (in other words, turn on the monitoring system

last). When turning off equipment, turn off the moni-

toring system first, and then turn off other equipment.

This helps to prevent “thumps” that can damage your

ears, and your equipment.

MIDI connections

MIDI instruments, controllers etc. should be con-

nected with their MIDI OUTs connected to the

MIDI

ports of the FW-1884.

The

MIDI OUT ports of the FW-1884 should be con-

nected to the MIDI IN ports of the external MIDI

equipment.

NOTE

Because the IEEE 1394 cable carries all MIDI information

to and from the FW-1884, including messages gener-

ated by the control surface, there is no need to make

any MIDI connection between the computer and the

FW-1884.

MIDI Routing

As explained earlier, the FW-1884 can be used to

route incoming MIDI messages to the

MIDI OUT ter-

minals, even when disconnected from a computer.

Here is how this works:

1 Press the

ROUTE key so that it flashes,

together with the top row of keys and indica-

tors.

2 Route MIDI INs to OUTs by pressing and

holding the appropriate

IN key and pressing

the appropriate

OUT key(s).

3 When complete, press the

ROUTE key once

more to exit the routing mode.

NOTE

The FW-1884 can merge the MIDI messages from the

different inputs and to the MIDI outputs. If you do

merge these messages, though, you should make sure

that there is only one MIDI clock source in the whole

MIDI system.

Analog audio connections

Each of the eight analog input channels is provided

with the following analog connectors

MIC, LINE IN

(BAL)

and INSERT.

When connecting analog equipment, use only one of

the

MIC or LINE IN connectors—do not connect ana-

log equipment to both at the same time.

The

MIC connectors may be supplied with +48V

phantom power. This is switchable for channels 1

through 4 or 5 through 8 using the rear panel

switches.

The

LINE connector for channel 8 can be switched to

match the impedance of an electric guitar or bass.

NOTE

Always take care when switching the phantom power,

to ensure that devices which may be damaged if phan-

tom power is supplied are not connected to XLR con-

nectors where phantom power is supplied.

Analog devices such as compressors, etc. may be

connected using standard 1/4" TRS connectors with

the

INSERT jacks. Use a special insert “Y” cable for

this, with a TRS 1/4" plug at the foot of the Y

(tip=send, ring=return), and the two branches fitted

with an unbalanced 1/4" plug.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Teac FW-1884 Setup Guide Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Teac FW-1884 Setup Guide